Front End Loader Grease Caps fits John Deere

Description

Keep your John Deere compact tractor loader in top condition with these durable grease zerk caps. They are designed to fit John Deere loaders including the 120R / 120E, 120R MSL, 220R / 220R MSL, 300R / 300E / 300E MSL, 320R, 400R / 400E / 400R MSL, and 520M. The caps cover your zerk fittings to extend equipment life and keep you clean.

John Deere loader grease zerks ship exposed, with no caps from the factory. By covering them, these caps keep dirt, dust, and moisture out of your lubrication points, so you are not pumping grit into the pin bores every time you grease. They also save you from the mess of brushing against an exposed zerk and getting grease on your clothes, gloves, or skin.

Why you need grease zerk caps:

• Protects exposed grease zerks and fittings so contaminants stay out and your pins and bushings last longer.
• Made for John Deere compact tractor loaders (120R, 220R, 300E, 320R, 400R, 520M).
• Keeps you clean by covering the zerk that would otherwise smear grease on you.
• Easy on and off with no tools.
• Affordable protection against expensive pin and bushing wear.

If you own a John Deere compact tractor, these grease zerk caps are a simple, low-cost way to protect your loader and keep your work area clean.

Frequently asked questions

Do John Deere loaders come with grease zerk caps?

No. The grease zerks on John Deere compact loaders are exposed from the factory, with nothing covering them. These caps add protection where there was none, so dirt does not get pumped into your pins.

Will these fit my John Deere loader?

They are designed for John Deere compact loaders including the 120R, 220R, 300E, 320R, 400R, and 520M (and their E / MSL variants). If you do not see your loader or are not sure, send us your loader model and a photo and we will confirm before you order.

Do I need any tools to install them?

No. They snap on and off by hand. Wipe each zerk clean first, then press a cap onto each fitting. The whole loader takes about five to ten minutes.

Will they stop pin and bushing wear?

They keep new dirt out of the fittings so you stop pumping grit into the pins going forward. They do not reverse wear that already happened. If your loader already has play or a knock at the pins, that wear is done, but capping the zerks protects what is left.

Do you make these for Kubota or New Holland loaders?

We make versions for other compact loaders. Zerk geometry varies by brand and model, so do not mix sets between brands. Contact us with your loader model and we will point you to the right one.

Are these manufactured in the USA?

Yes. Manufactured in the USA from globally sourced materials.