If you spend any time in compact tractor forums, you will see the same photo posted again and again: a cracked hood latch on a John Deere 1025R, 2025R, 2032R, or similar. Same crack pattern every time. Same starting point. This is not bad luck or rough use. It is a predictable failure mode in…
The factory hood release on a John Deere compact tractor is for regulatory compliance, not for the person who has to open the hood every day. Owners notice fast. Most figure out a workaround. A small number replace the factory release with something better. What the factory release is like Requiring a key or an…
The adhesive on the Hood Saver is designed to set on a clean, room-temperature hood surface. About 95 percent of installs work the first time. The other 5 percent run into one of three things: cold install temperature, residue on the hood, or a tab geometry that needs a second pass. All three are fixable….
Hood Saver – Installation Instructions John Deere 1023E, 1025R, 1026R, 2025R, 2032R, 2038R Tools Required 10mm socket Flat head screwdriver or small pry bar Sandpaper (light grit) Permanent marker Isopropyl alcohol and lint-free cloth Eye protection and impervious gloves Well-ventilated area (for glue application) About the adhesive Plastic glue (included) is recommended for all installations….
Hood Release – Installation Instructions John Deere 1, 2, 3, and 4 Series compact tractors ▶ Prefer video? Watch Tractor Time with Tim install his on YouTube Tools Required 11mm (7/16″) socket or wrench A thumbwheel or open-end wrench is preferred over a ratchet – easier to feel when you’re at snug Removal 1 Open…